NEC UNIVERGE NEAX IPS-DMR Phone Systems Go Back Back to #PrePage#
NEC UNIVERGE NEAX IPS-DMR
The NEC UNIVERGE NEAX IPS-DMR is designed specifically as an IP Remote PIM (Physical Interface Module) application offering for NEC's NEAX 2000 IPS product family. It can not be used as a standalone system. It supports traditional analog and digital trunks for connection to the Public Switched Telephone Network (PSTN). It supports up to 128 peer-to-peer IP stations and 56 TDM ports in a single modular chassis. It provids solutions for you to extend features available at headquarters over an IP WAN remote location with minimal incremental cost.
Find NEC UNIVERGE NEAX IPS-DMR Phone Systems dealers nearest you!
 
NEC UNIVERGE NEAX IPS-DMR Phone System
 

NEC UNIVERGE NEAX IPS-DMR
NEC UNIVERGE NEAX IPS-DMR Benefits:
#ShuffleList(BenefitsList)#

NEC UNIVERGE NEAX IPS-DMR
NEC UNIVERGE NEAX IPS-DMR Features:
#ShuffleList(FeaturesList)#

NEC UNIVERGE NEAX IPS-DMR Specifications:
Rotary Dial Pulse

(1) Receiving Conditions
Dial Speed: 9 ~ 11 pulses per second (pps)
Break Ratio: 55 ~ 77% (10 pps)
Minimum Inter-digital Pause: 192 ms
Switch Hook Flash Detection: 310 ~ 1610 ms a.

(2) Sending Conditions
Dial Speed: 10 pps (±0.8 pps)
Break Ratio: 67 ±3%
Minimum Inter-digit Pause: 800 ms
DTMF Signaling

(1) Receiving Conditions (Measured at Receiver Input)
Signal Duration: More than 40 ms
Inter-digital Pause: More than 40 ms
Signal Level: 0 ~ -25 dBm

(2) Sending Conditions
Signal Duration: More than 64 ms
Inter-digit Pause: More than 64 ms
Signal Level:
Low Frequency: -10 dBm
High Frequency: - 9 dBm


Audible Tones
TONE FREQUENCY INTERRUPTION
Dial Tone (DT) 350 Hz mixed with 440 Hz Continuous
Special Dial Tone (SDT) 350 Hz mixed with 440 Hz 0.125 sec. ON, 0.125 sec. OFF
Busy Tone (BT) 480 Hz mixed with 620 Hz 0.5 sec. ON, 0.5 sec. OFF
Reorder Tone (ROT) 480 Hz mixed with 620 Hz 2.5 sec. ON, 0.25 sec. OFF
Howler Tone (HWT) 2,400 Hz interrupted by 16 Hz Continuous
Service Set Tone (SST) 350 Hz mixed with 440 Hz Continuous
Ring Back Tone (RBT) 440 Hz mixed with 480 Hz 1 sec. ON, 3 sec. OFF
Hold Tone (HDT) 480 Hz mixed with 620 Hz 0.25 sec. ON, 0.25 sec. OFF
0.25 sec. ON, 1.25 sec. OFF
Second Dial Tone 440 Hz mixed with 480 Hz 0.25 sec. ON, 0.25 sec. OFF
0.25 sec. ON, 1.25 sec. OFF
Call Waiting Ringback Tone 440 Hz mixed with 480 Hz 1 sec. ON, 1 sec. OFF
Message Waiting Indication Tone 350 Hz mixed with 440 Hz 0.125 sec. ON, 0.125 sec. OFF


Ringing Signal
Frequency: 20 Hz (Nominal)
Signal Voltage: 75 Vrms (Nominal)
Interruption: (1) 2 sec. ON, 4 sec. OFF (external calls)
(2) 1 sec. ON, 2 sec. OFF (internal calls)
Note: Distinctive ringing is available for trunk routes and class of service options.

Heat Dissipation
PIM NO. MAX. AC POWER CONSUMPTION (W/H)* MAX. BTU (BTU/H)
1 145 494
2 290 988
3 435 1481
Note: 1 W/H = 3.4056 BTU

VARSearch currently features NEC UNIVERGE NEAX IPS-DMR dealers from the following states:

#TheStateName#